Workflow starts with half instance of object

[Robert van den Berg]

Oooeeehhh.. Guru! That's a nice one Kjetil! I will look into that.
 
On Jul 10, 2013 11:34 "Kjetil Kilhavn" <list.sap-wug at vettug.no> wrote:
> Onsdag 10. juli 2013 08.11.18 skrev Robert van den Berg:
> > i have a custom BOR object build with a few virtual paramaters.
> > When I test the workflow by raising an event, the workflow starts
> > but
> > goes in error because a virtual parameter is nog yet instanciated.
> > When
> > I refresh the container, the rest of the virtual parameters is
> > instanciated and now the workflow can be continued after error.
> > How can I make sure the workflow only continues when the object is
> > fully
> > instanciated?
> The general solution is to add a step condition (work item creation)
> which
> checks whether this attribute has a valid value yet. This works
> regardless of
> the length of the delay, and there won't be any additional steps in
> the
> workflow. The delay may be increased though, since the condition check
> is only
> executed every so often (I think the default is every 30 minutes).
> I discovered the usefulness of this when one of my solutions failed
> because
> new employees were registered without e-mail address and without SAP
> user
> name, and it would sometimes take days before the e-mail address was
> registered - and some employee numbers were not to have SAP users.
> Wait steps are so 2005 :-)
> > Kind regards,
> > Robert
> -- 
> Kjetil Kilhavn / Vettug AS (http://www.vettug.no)
> _______________________________________________
> SAP-WUG mailing list
> <SAP-WUG at mit.edu>
> <http://mailman.mit.edu/mailman/listinfo/sap-wug>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.mit.edu/pipermail/sap-wug/attachments/20130710/8357165d/attachment.htm