Problem in production server

[PEOU Tom T]

Hi Sharath,

 

There is no problem with restarting a Workflow through SWI2_DIAG.

However, if the restart does not fix the error, then you will need to
investigate.

 

If a Workflow goes into error on the start step, then I would suggest
that you check the following:

1. Check that the PA20 infotype 105 record exists for the initiator and
the recipient.

2. Ensure that the validity date for that record is active (end date
greater than today)

3. Ensure that the SU01 record exists and is valid for the recipient.

 

Good luck.

 

Tom

 

 

 

 

 

 

 

 


IMPORTANT NOTICE: This e-mail and any attachment to it are intended only to be read or used by the named addressee. It is confidential and may contain legally privileged information. No confidentiality or privilege is waived or lost by any mistaken transmission to you. The RTA is not responsible for any unauthorised alterations to this e-mail or attachment to it. Views expressed in this message are those of the individual sender, and are not necessarily the views of the RTA. If you receive this e-mail in error, please immediately delete it from your system and notify the sender. You must not disclose, copy or use any part of this e-mail if you are not the intended recipient.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.mit.edu/pipermail/sap-wug/attachments/20050620/382c5da7/attachment.htm