Event not terminating the workitem

[Michael Pokraka]

Hi Uzi,
Very strange that it complains about a triggering event for what is a
terminating event.
Try SWUD - consistency check on your workflow and task and then try the f=
low
again. I've seen that run successfully and yet it solves problems that
simply did not make sense.
 
Cheers
Mike
 
Amit, Uzi wrote:
> Dear Workflow collegues,
>
> Please have a look at the following problem:
>
> 1. An a-sync. task is defined with a terminating event.
> 2. The task starts correctly, a workitem is created.
> 3. The terminating event is raised by the application (via status chang=
e)
> 4. The event does not complete (terminate) the workitem
> 5. The workitem remains in status: in process.
>
>
> When checking the event trace, I see that the event is linked to the
> workitem, but I get the following error message:
>
> *********************
> Event ZBUS2001 STATUS_PLC1 for task WORKITEM not defined as start event
> Message no. WL610
>
> Diagnosis
> The tuple specified (object type, event) is not defined as a triggering
> event for the specified task.
>
> System Response
> The action was cancelled, the task was not started.
>
> Procedure
> Check the task definition. Make sure the entries in the task definition
> conform to the entries in the type linkage table of the events.
> **********************
>
> In the event trace, I can see that the receiver FM is:
> SWW_WI_COMP_EVENT_RECEIVE_IBF.
>
> All the settings in the task definition seem to be OK.
>
> Does anyone have an idea how to aproach this problem ?
>
> Thank you very much
> Best regards,
> Uzi Amit
>
>