Workflow trigger event & start condition issue

[Weidong Yang]

Hi Jocelyn and Arvindh,
 
Thanks for your advice! I found that the problem was in the Workflow =
builder in which one couldn't see the start condition in our QA system, =
even the condition is there if I use SWB_COND. The workflow is working.
 
 
Weidong =20
 
-----Original Message-----
From: Dart, Jocelyn [mailto:jocelyn.dart at sap.com]
Sent: Monday, June 30, 2003 12:52 AM
To: SAP-WUG at MITVMA.MIT.EDU
Subject: Re: Workflow trigger event & start condition issue
 
 
Hi Les/Weidong,
This has been answered in this list before.  Please take it up with OSS =
if you are still having problems.
It's possible you are missing a few OSS notes if you are on 4.6C or =
below.
Even if you are you can always transport the relevant table entries =
directly by using transaction SE16 (tables SWBRULE*,etc. ) to add the =
entries to a change request.
 
However the main thing to remember is that event linkages and start =
conditions are both client-dependent whereas the workflow itself is =
client-independent, so they have most likely been added to different =
change requests. So if you only transported the client-independent =
change request that might be part of your problem.
 
Regards,
        Jocelyn Dart
Consultant (SRM, EBP, Workflow)
and co-author of the book
"Practical Workflow for SAP"
SAP Australia
email: jocelyn.dart at sap.com
phone: +61 412 390 267
fax:   +61 2 9935 4880
 
 
 
 
 
-----Original Message-----
From: Stiles, Les [mailto:Les.Stiles at icn.siemens.com]
Sent: Friday,27 June 2003 11:47 PM
To: SAP-WUG at MITVMA.MIT.EDU
Subject: Re: Workflow trigger event & start condition issue
 
 
I posted the same problem last week and no one had a solution. Our BASIS
guru is supposedly investigating. If he figures it out, I will post to =
the
forum. In the meantime, he is going to open the "non-modifiable" QA =
systems
to allow to set the Start Conditions directly as an interim fix.
 
Les Stiles
Systems Analyst, QM & WF
Siemens ICN
400 Rinehart Rd
Lake Mary FL 32746
(407) 942-6777
les.stiles at icn.siemens.com
 
 
-----Original Message-----
From: Weidong Yang [mailto:wyang at apotex.com]
Sent: Friday, June 27, 2003 8:51 AM
To: SAP-WUG at MITVMA.MIT.EDU
Subject: Workflow trigger event & start condition issue
 
 
Hi there,
 
I had a issue with the trigger event assignment as well as start =
condition.
 
I create a workflow and assign an trigger event as well as a start
condition. After transport to QA, I can't see the start condition as =
well as
trigger event I had in the DEV system. There is nothing there. When I
checked the table for start and event table in QA, all the value are =
there.
 
 
Does anyone have the same issue before? Thanks in advance!
 
 
Weidong