Start Conditions in 4.6c

[Nobles, Diane]

Good morning all.  Still working on the start conditions issue.  Yesterday
we found out the condition table in target development client only had one
entry and it was a delete, from one workflow.  The source development client
had at least 20 entry's for all the workflows (4).  We noticed that the one
and only entry in the target dev client, the transport responsible showed
the table listed
(SWBRULECOM ) none of the other transports (one for each workflow) had an
entry for this table.  I researched OSS and found two notes addressing
writing to this table, unfortunately we have already  installed these
changes as part of hot packs.  Still we have the problem.  We have copied
each transport twice already.  Has anybody else experienced this situation
and/or have a possible solution, other than opening the client???  Thanks in
advance for any information.
 
Diane H. Nobles
SAP Proj. Analyst, PM, WF
(757) 380-7250
 
 
-----Original Message-----
From: John A Haworth [mailto:jhoworth at csc.com]
Sent: Wednesday, September 04, 2002 4:09 AM
To: SAP-WUG at MITVMA.MIT.EDU
Subject: Re: Start Conditions in 4.6c
 
 
Hi
 
I had a similar problem whereby the check function module that is created by
the graphical tool had not transported correctly, as seen in the event
linkage table. I had to re-transport.
 
John
 
 
 
                    "Nobles,
                    Diane"               To:     SAP-WUG at MITVMA.MIT.EDU
                    <nobles_dh           cc:
                    @naptheon.com        Subject:     Start Conditions in
4.6c
                    >
                    Sent by: SAP
                    Workflow
                    <Owner-SAP-WU
                    G
 
 
                    03/09/2002
                    21:49
                    Please
                    respond to
                    "SAP Workflow
                    Users' Group"
 
 
 
 
 
 
Good afternoon all.  Workflow start conditions are inplace and appear to be
correct.  The SWB_CHECK_FB_START_COND_EVAL function module shows up in the
event linkage table.  However, the workflow starts on any and all conditions
whether true or false. Has anyone ran into this situation?  Have not found
an OSS Note that might apply.  What could be missing???
 
Diane H. Nobles
SAP Proj. Analyst, PM, WF
(757) 380-7250