Start Conditions in 4.6c

[Pokraka, Michael]

This might be obvious, but always worthwhile checking the event log. If a
start cond is evaluated and fails, there should be an entry to that effect
in there.
Check SWU0 to make sure what's happening off the back end of the event. SWUE
is also always a good place to kick things off.
Alternatively, you can plug in a custom start condition which raises an
exception just to check (assuming this in on your dev system).
HTH
Mike
 
-----Original Message-----
From: Nobles, Diane [mailto:nobles_dh at naptheon.com]
Sent: 03 September 2002 21:49
To: SAP-WUG at MITVMA.MIT.EDU
Subject: Start Conditions in 4.6c
 
 
Good afternoon all.  Workflow start conditions are inplace and appear to be
correct.  The SWB_CHECK_FB_START_COND_EVAL function module shows up in the
event linkage table.  However, the workflow starts on any and all conditions
whether true or false.
Has anyone ran into this situation?  Have not found an OSS Note that might
apply.  What could be missing???
 
Diane H. Nobles
SAP Proj. Analyst, PM, WF
(757) 380-7250
 
------------------------------------------------------------------------------
This e-mail is intended for the use of the addressee(s) only and may contain privileged, confidential, or proprietary information that is exempt from disclosure under law.  If you have received this message in error, please inform us promptly by reply e-mail, then delete the e-mail and destroy any printed copy.   Thank you.
 
 =============================================================================