General Task. How to terminate the workflow if no agent specified .....

[Parag Joshi]

Hi Vanathy,
 
As suggested by Peter, standard-role config can do the job.
 
Additionally, if the requirement is that not to trigger
workflow under certain conditons then such custom requirements
can be achieved via Check FMs. Check FMs are quiet handy, as it
avoids unnecessary processing overhead if workflow should not
be triggerred under certain conditions.
 
Check FMs can be attached in Event-Receiver linkage table(SWE2).
 
Regards.
 
Parag Joshi.
Senior SAP Consultant. Workflow/Interfaces(EDI/ALE/EBP/APO)
3S Inc USA.
Tel: 1-317-640-1115
 
 
 
 
 
---- On    , Ulagapiragasam Vanathy
(Vanathy.Ulagapiragasam at au.bosch.com) wrote:
 
> Hi
>
> We have created a workflow template which gets kicked on when
some one
> creates an Quality
> notification task (QM01). This task is specified as 'General
task' .
>
> An agent has to be assigned to the Quality notification task
before
> saving.
> If agent is not assigned and try to save the task
> it gives waring message. Though if you ignore and save it,
the work item
> is
> sent out to everyone in the company. How can we
> avoid this and 'Terminate' the workflow for this scenario? A
>
> Any help would be appreciated.
>
> Thanks in advance
> Vanathy
>
>
 
 
________________________________________________
Get your own "800" number
Voicemail, fax, email, and a lot more
http://www.ureach.com/reg/tag