QN Workflow

[Pokraka, Michael]

Hmmm, depends slightly on your landscape. Our setup sounds similar to the
one you describe:
We can develop in the dev client 100 (using your numbers), but then
client-specific settings have to be carried out in test client 030.
The CTS is configured to only record changes in 100, so you can do
transport-independent config in 030.
In other words, transport your event linkage from 100, but
activate/deactivate as you wish for testing in 030. As we're also on 46c,
this should be similar to your setup.
Cheers
Mike
 
 
-----Original Message-----
From: Nobles, Diane [mailto:nobles_dh at naptheon.com]
Sent: 16 August 2002 15:36
To: SAP-WUG at MITVMA.MIT.EDU
Subject: QN Workflow
 
 
Good morning all.  The saga continues.  I have created a workflow definition
and events etc., however, the events are only showing up in the WFdefinition
in the client it was created in.  Our basis team only allows creation of
objects and WF definitions in DVN100.  The boxes were data exists and I need
to test, the WF definition can not be changed.  Do the event triggers have
to be set in each client, i.,e, DVN100 is our ABAP develop client, DVN030 is
our functional development client were the data exists???  Our system is
4.6c.
 
Diane H. Nobles
Northrop Grumman-Naptheon
SDE PM Team
(757) 380-7250
 
------------------------------------------------------------------------------
This e-mail is intended for the use of the addressee(s) only and may contain privileged, confidential, or proprietary information that is exempt from disclosure under law.  If you have received this message in error, please inform us promptly by reply e-mail, then delete the e-mail and destroy any printed copy.   Thank you.
 
 =============================================================================