how to restart the workflow

[Keohan, Susan]

Hello IKhan,

I have to wonder, why are you checking the RFC destination in your WF ?  This should be done once, and not need to be done again unless you upgrade or your Basis people get loopy.  But I digress.

Since the workflow is not really in error, there is no need to restart it.  What you need to do is be able to model the workflow so that once the system administrator re-sets your RFC destination, you can get back to the start of your condition step.  Setting a few flags here and there, and use of branching or loops should do the trick.

----
Susan R. Keohan
SAP Workflow Specialist
MIT Lincoln Laboratory
244 Wood Street, LI-200
Lexington, MA.  02420
Ph:   781-981-3561
Fax: 781-981-1607
keohan at ll.mit.edu

From: sap-wug-bounces at mit.edu [mailto:sap-wug-bounces at mit.edu] On Behalf Of IKhan
Sent: Monday, November 12, 2007 10:38 PM
To: SAP Workflow Users' Group
Subject: how to restart the workflow


Hi friends,
   I have a requirement where in i am checking inside the workflow whehther the rfc destination is maintianed using a condition step  and if it fails i have to  exit processing completely and send a workitem to an administrator informing them of the issue and Allow the possibility for the workflow to be restarted again once the table has been updated.How to do allow the possibility of restarting the workflow.

rgds,
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.mit.edu/pipermail/sap-wug/attachments/20071113/38c03f25/attachment.htm