Stubborn Start Conditions.

[Shalini Sabnani]

Gavin, I did use t-code SWB_COND to create my start conditions.  Thankks


On 2/12/07, Gavin Mooney <gavinmooney at gmail.com> wrote:
>
> Shalini,
>
> Just use SWB_COND to create/edit the start conditions. If you get to
> the start conditions from the workflow builder and then change them in
> SWB_COND sometimes the sort of behaviour you describe can occur.
>
> Regards,
> Gavin
>
>
> 2007/2/12, Shalini Sabnani <workflow.mail at gmail.com>:
> > Hello WUGers
> > I am suffering from a case of  "Stubborn Start Conditions" in ECC 6.0
> > When you add or modify Start Conditions you should normally have the
> start
> > conditions saved in 3 tables
> > -SWBRULECOM
> > -SWETYPEENA
> > -SWETYPECOU
> > In R/3 4.6c, very often, when we modified Start Conditions they were not
> > saved in all the 3 tables above, we would then edit the workflow using
> > SWDD_CONFIG and this would make sure the Start Conditions were in all 3
> > tables.
> >
> > In ECC 6.00 however, SAP does not allow us to edit and save config on
> Custom
> > workflows using t-code SWDD_CONFIG. My start conditions for the Travel
> WF in
> > question is only saved in SWBRULECOM  and I am not sure what I should do
> to
> > save/record them in the other 2 tables.
> >
> > Any ideas you may have are welcome.
> > Thank You
> > Shalini
> >
> >
> > _______________________________________________
> > SAP-WUG mailing list
> > SAP-WUG at mit.edu
> > http://mailman.mit.edu/mailman/listinfo/sap-wug
> >
> >
> _______________________________________________
> SAP-WUG mailing list
> SAP-WUG at mit.edu
> http://mailman.mit.edu/mailman/listinfo/sap-wug
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.mit.edu/pipermail/sap-wug/attachments/20070212/6f00ff10/attachment.htm