Cannot Transport Workflow from ECC 5.0 to Release 4.6C

[NICKLAS, Christian]

Some additional Information:

At some templates it is not possible to display the workflow template
->  A short dump is created                                 
 "MESSAGE_TYPE_UNKNOWN"            
 "SAPLSWDE " or "LSWDEU17 "        
 "SWD_WF_DEFINITION_ERROR_NOTIFY"  

At other templates, weher I can enter the template and than want to
start the builder with the definition, I can only do this in the edit
mode. But the definition is empty. When I try to change version, I can
display the version 0 in the extra dynpro (the correct transported
version) but when I want to get the 0-version in teh edit mode, I get
the following error:
Internal program error: WORKFLOW_REFRESH_TREE 0005 OFF
0005 When a function block was modified, a program error occurred since
the number of old and new subsequent nodes is not consistent. 

Release 4.6C - SAPKB46C47
Release ECC5.0 - SAPKB64016

Any hints are welcome.

Regards
Christian 


Hi flowies,

I have a problem transporting a workflow, developed under ECC 5.0 on our
4.6C System.
In the transport log I can see many tables which do not exist under our
4.6C-System where workflow definition data is stored (e.g. SWDSCONT,
HRSCONT, SWDSDSTEPS,... and many more)

In the builder I get the message, that the definition in the
corresponding version does not exist, when trying to display the
definition.

Is there any way to transport a workflow from a higher release to a
lower one? (ECC 5.0 -> 4.6C? or 4.7)

Regards
Christian



_______________________________________________
SAP-WUG mailing list
SAP-WUG at mit.edu
http://mailman.mit.edu/mailman/listinfo/sap-wug