Methodes using f.m. with qRFC ?

[Maes Steven]

Heinz,

 

You can trigger the events without using the event-queue. Just shut it
down. The events will trigger the WF direct.

Be sure to think about the consequences. When you trigger 100 events in
10 seconds, ...

 

Regards,

 

Steven 

 

  _____  

Van: Schmidinger, Heinz (Unaxis IT BZ)
[mailto:heinz.schmidinger at unaxis.com] 
Verzonden: dinsdag 7 juni 2005 15:49
Aan: SAP-WUG at mit.edu
Onderwerp: Methodes using f.m. with qRFC ?

 

Hi Workflowers,

I'm fighting with a stupid problem. Maybe someone of you can help me to
see the way.

I have a Task (TS) executing a Method based on a f.m. (running without
problems). The task is triggered by some starting events (running fine).

The need is to run the task in the order the events are received
(sequential). Normally this would be done by using the event-queue.

In this special business case the minimum max.delay of 1 minute is to
high, the start should be immediately.

So I had the idea to use a qRFC-f.m. This qRFC-f.m. run on destination
'NONE'.

When I test the f.m. calling the qRFC out of SE37, all works fine so
long.

But if I run the Task by creating the starting Events, the Task is
created correct but no result can be seen.

It looks like that nothing happens. Frustrated I cann't find no entry in
ST22 or SM58. Also I cann't see any entry in the qRFC-Administration.

Is it not possible to use qRFC's out of Workflow-Environment ?

Or do I have some more knowledge gaps where I have to look for and how I
have to install and maintain qRFC's ?

Can anybody help ?

Thanks in advance

Best regards

Heinz

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.mit.edu/pipermail/sap-wug/attachments/20050607/e551a990/attachment.htm