Runtime Version in EBP 3.0

[Omkaram, Raju]

Hello Jocelyn,
 
I always run swu_OBUF after each change I make to Workflow. I heard
something similar from an EBP consultant who worked on other clients and
experienced the same. After the transport, I verify the version and
recompile the object and workflow. Also run SWU_OBUF. Do you think it could
the system environment issue?
 
Thanks for the prompt reply.
 
-----Original Message-----
From: Dart, Jocelyn [mailto:jocelyn.dart at sap.com]
Sent: Monday, February 16, 2004 7:15 PM
To: SAP-WUG at MITVMA.MIT.EDU
Subject: Re: Runtime Version in EBP 3.0
 
 
Hi Raju,
Process in EBP is no different than in any other system.
Are you sure you saved and activated the workflow and used txn SWU_OBUF to
refresh the
buffer so that the new version of the workflow was used at runtime?
Jocelyn
 
-----Original Message-----
From: SAP Workflow [mailto:Owner-SAP-WUG at MITVMA.MIT.EDU] On Behalf Of
Omkaram, Raju
Sent: Tuesday,17 February 2004 2:26 AM
To: SAP-WUG at MITVMA.MIT.EDU
Subject: Runtime Version in EBP 3.0
 
 
Hi,
 
Whenever I make a change to an EBP workflow, those changes are not being
captured. I tried creating a new version just so that it would make a
difference but no luck. I had to copy the workflow to a new one and then it
works. I do not think this is the case in R/3. Is this behavior typical in
EBP 3.0? Is there a note to correct this?
 
Thanks
 
Raju Omkaram
SAP Competency Center
Miller Brewing Company
Phone 414-931-3086