Newly created Event parameters are not recognized by WF
Robert vdBerg
Robert.vande.Berg at nuon.com
Fri Jun 6 04:01:04 EDT 2003
I have had the same problem.
You have to recheck the bindings in the workflow. Even if you change =
the
type of the container element, the workflow must see the change!
Save the workflow and it works fine!!
Good luck!
Robert van den Berg
Accenture Technology Solutions
-----Oorspronkelijk bericht-----
Van: Schmidinger, Heinz (Unaxis IT BZ)
[mailto:heinz.schmidinger at unaxis.com]
Verzonden: donderdag 5 juni 2003 17:59
Aan: SAP-WUG at MITVMA.MIT.EDU
Onderwerp: AW: Newly created Event parameters are not recognized by WF
Hi Weidong,
do you have checked the parameter-direction (IMPEORT/EXPORT) ?
Maybe there is the problem.
An other thing is that BO-Changes are not accessable for other =
functions
until the BOBuilder is left.
maybe it helps.
regards
heinz
-----Urspr=FCngliche Nachricht-----
Von: Weidong Yang [mailto:wyang at apotex.com]
Gesendet am: Donnerstag, 5. Juni 2003 17:51
An: SAP-WUG at MITVMA.MIT.EDU
Betreff: Newly created Event parameters are not recognized by WF
Hi there,
I created an event for subtype of BUS1001 and a parameter PLANT for the
event. The event is working fine and can trigger the WF correctly, but =
the
parameter I defined for that event is not available for WF. Where did I =
do
wrong? Thanks in advance.
By the way, where can I find the archive of this mail list?
Weidong
More information about the SAP-WUG
mailing list