Keep workflow running even though error detected

[Kevin Yu]

Hi Bodo,
 
Thanks.  The workflow that have had problem is the PO release workflo=
w
and it's been running for one and half day.  It suddenly complained
about the mandatory element Releasecode is missing and deactivated th=
e
linkage type.  We cannot simulate the problem in Development and
Testing.  Do you think it's to do with the Buffer - such as not enoug=
h
buffer space?  Once re-activated, it comes again after a couple of
hours.  I am not sure it's a genuine blank Releasecode or not.
 
Is there anyone has had this problem before?
 
Kevin.
 
 
"LANGE, BODO" wrote:
>=20
> Hi Kevin,
> usually the Event linkage is turned off if there is an error during=
 exchange
> of data
> between the Event Parameter container and the workflow container. Y=
ou should
> check your
> data types of your developed workflows and see if they have changed=
 after
> the upgrade.
> Maybe you have a type or length mismatch in one of your parameters.=
 Simulate
> your Workflow Event and check your Event log.
>=20
> Good luck
>=20
> Bodo Lange
>=20
> -----Original Message-----
>> From: Kevin Yu [mailto:kevin.yu at its.monash.edu.au]
> Sent: venerd=EC 3 maggio 2002 8.46
> To: SAP-WUG at MITVMA.MIT.EDU
> Subject: Keep workflow running even though error detected
>=20
> Hi,
>=20
> We are in 46C.  The upgrade just went live four days ago.  It seems=
 that
> in 46C if there is any error detected the system will just switch o=
ff
> the Event Type Linkage.  In 40B, even though an error detected it j=
ust
> sent an Inbox to the workflow administrator and the workflow just k=
ept
> on running.
>=20
> In 46C, the error message still sent to the Workflow administrator =
but
> the system will automatically unchecked the Type linkage active box=
 in
> the Event type linkage.
>=20
> Is there any way or config ..etc to set so that even there is error=
 the
> system will not inactive the Type Linkage?
>=20
> Thanks,
>=20
> Kevin.