AW: Start condition is missing after tranport

[Becker Stephan (extern)]

There are also two OSS notes with a source code correction (316610 and
350026) that you might want to have a look at.. thanks for posting this =
at
the right time, reminded me to transfer my start conditions just in =
time for
integration test :-)
 
Stephan
 
-----Urspr=FCngliche Nachricht-----
Von: David Weston [mailto:weston at clockwork.ca]
Gesendet: Dienstag, 2. April 2002 23:05
An: SAP-WUG at MITVMA.MIT.EDU
Betreff: Re: Start condition is missing after tranport
 
 
Hi Weidong,
 
I have had this problem in the past. My solution was to go to SE16 for =
table
SWBRULECOM and mark the entries that need to be transported under the =
menu
path
'Table entry --> Transport entries' when displaying the table contents.
 
Pretty basic but it worked.
 
Cheers
Dave
 
 
-----Original Message-----
From: SAP Workflow [mailto:Owner-SAP-WUG at MITVMA.MIT.EDU]On Behalf Of
Weidong Yang
Sent: Tuesday, April 02, 2002 3:26 PM
To: SAP-WUG at MITVMA.MIT.EDU
Subject: Start condition is missing after tranport
 
 
Hi WF expert,
 
After successfully tranporting my WF to QA system, I found that the =
start
condition for triggering this workflow is not transported. I tried to
re-created a start condition using SWB_COND and the system does not =
allow me
to create it. Any suggestin will be greatly apreciated.
 
 
Weidong
 
_________________________________________________________________
Send and receive Hotmail on your mobile device: http://mobile.msn.com