SSO and SAP

[Tim Alsop]

Laura,

In addition to Eric's note - You also need to be aware that there are a
few commercial products available which use Kerberos for SAP Security,
and SSO, that are fully supported, and some are SAP Certified to work
with the SNC interfaces, so if your company is planning to use SNC with
Kereberos, and are concerned about being supported you should consider
looking at one of the SAP Certified products available which use the SNC
interface. The SAP website lists them. I can send you the URL if you are
interested.

Thanks,
Tim 

-----Original Message-----
From: kerberos-bounces at mit.edu [mailto:kerberos-bounces at mit.edu] On
Behalf Of Labiner
Sent: 20 September 2006 12:34
To: kerberos at mit.edu
Subject: Re: SSO and SAP

Hi Laura,

There's a document about SSO config for SAP on Linux:
http://mailman.mit.edu/pipermail/kerberos/2004-November/006640.html

The general steps are:
1. Install MIT Kerberos on the Unix machine.
2. Compile the SAP SNC adapter.
https://www.sdn.sap.com/irj/sdn/thread?messageID=2298312
ftp://ftp.sap.com/pub/ietf-work/gssapi/
3. Follow the general SNC configuration scenario SAP:
http://help.sap.com/saphelp_nw2004s/helpdata/en/44/0ebb40b9920d1be100000
00a114a6b/frameset.htm

Have a read here too:
https://www.sdn.sap.com/irj/sdn/thread?messageID=2298312

A small note: SAP does not support any problems with the MIT krb and
the snc adapter is a discontinued product.

I'm doing the same pilot for AIX 5.3.

Regards,
Eric Labiner
SAP NetWeaver consultant

________________________________________________
Kerberos mailing list           Kerberos at mit.edu
https://mailman.mit.edu/mailman/listinfo/kerberos