Manually Activate/Deactivate WF Event Linkage in Non Modifiable System (e.g. Production) without a transport
Morris, Eddie
eddie.morris at sap.com
Tue Sep 13 09:30:15 EDT 2011
Hi Sheldon,
Note 1376011 was created to prevent the event linkage being activated in a locked system. I guess this is not yet in your 700 system (Correction comes with support pack SAPKB70021) but is in your 702 system (Correction comes with support pack SAPKB70202).
Regards,
Eddie
-----Original Message-----
From: sap-wug-bounces at mit.edu [mailto:sap-wug-bounces at mit.edu] On Behalf Of Sheldon Oxenberg
Sent: 08 September 2011 19:53
To: SAP Workflow Users' Group
Subject: Manually Activate/Deactivate WF Event Linkage in Non Modifiable System (e.g. Production) without a transport
In ECC 6.0 Basis Release 700, I can manually Activate/Deactivate a WF Event
Linkage in a Non Modifiable System (e.g. Production) without a transport.
In ECC 6.0 Basis Release 702, I cannot manually Activate/Deactivate a WF
Event Linkage in a Non Modifiable System (e.g. Production).
Is there an ECC 6.0 Basis Release 702 config that permits manual
Activate/Deactivate of a WF Event Linkage in a Non Modifiable System (e.g.
Production)?
Otherwise if a transport is required (not useful in an emergency), is there
a WF Administrator utility/function to Activate/Deactivate a WF Event
Linkage in Prod?
Thank you very much.
SHELDON OXENBERG
System Architect Principal Leader
LMP Technical Architect, SAP Workflow
CSC
_______________________________________________
SAP-WUG mailing list
SAP-WUG at mit.edu
http://mailman.mit.edu/mailman/listinfo/sap-wug
More information about the SAP-WUG
mailing list